Pull-up bar Starterhorn

Special Version for Maximum Loadingn

For an additional cost, a version is available with two welded mounts, whereby two M12 bolts hold the bar on each side.  Furthermore, the wall thickness of the bar is 3 mm, as opposed to 2.5 mm for the standard version.

With this, simultaneous turning of the bar during heavy loading, e.g. during swing exercises, is reliably avoided.​

The screws on here are provided with rounded heads, so that, on the inside of the gym bar, no risk of injury is presented by protruding screw heads.

The screws on the outside also have no sharp edges, achieved by using self-locking capping nuts.​

Adjustment of the gymnastic bars

In stainless steel with quick adjustments:
Attaching the horizontal bar, as well as adjusting the height, is done using two M12 star-shaped screws. For this reason, the horizontal bar has a CNC-milled turned part at both ends, which each have an M12 thread. In addition, the two contact surfaces are attached to the post with a knurl to effectively prevent the rods spinning.

Quick adjustment of the gymnastic bars

For the two fastening methods described above, we have developed a quick adjustment method for each of them, which are quite different to the assembly.​ Both methods are characterised by the ability to quickly adjust the height without the use of tools.​​

Standard version with an M12 central screw

The central screw has a massive star grip, which allows you to tighten the rod on each side.

Special version with welded latches

For this version, we supply 2 powerful star grip nuts for each side, which you can use to quickly tighten or loosen the two M12 screws.

Assembly and installation of the equipment

In principle, the equipment can be installed at any installation site. The posts are secured in concrete foundations, which are approx. 60 cm deep. The stainless steel posts are cemented directly into the cement, the wooden posts in galvanized wooden post anchors.

To ensure seamless installation, you will receive:

• All the required fixtures and fittings. The only thing missing is the ready-mixed concrete (sacks of concrete mix are available at hardware shops)
• Assembly instructions, incl. foundation plans and elevation sketches
• Threaded rods incl. screw connections for millimetre precision alignment of the equipment

Alignment using threaded rods

The parallel, perpendicular and exact alignment of the posts is of huge importance for stable installation of the equipment. By using the M12 size threaded rods and the horizontal bars, the equipment can be exactly aligned before concreting. This way, the distance of the posts will be ensured with millimetre precision until the concrete hardens.

Floor design

Lawn can be used for the floor, but fall-protection mats or sheets have better properties. These items are available from specialty stores in square or rectangular shapes and in different colours. In comparison to grass, these mats offer better protection against falls. 
In addition, combining the mats with the wood-stainless steel products, will make the design of your play equipment very appealing.

Principle sketch

Floor design with fall protection plates

Use of threaded rods